When comparing ODROID-W vs Intel NUC Kit NUC7i3BNH, the Slant community recommends Intel NUC Kit NUC7i3BNH for most people. In the question“What are the best single-board computers?” Intel NUC Kit NUC7i3BNH is ranked 27th while ODROID-W is ranked 64th. The most important reason people chose Intel NUC Kit NUC7i3BNH is:
While the cost may seem steep compared to other SBC options, seldom are those other options sold with a case that will also house your storage drives and provide adequate cooling for the entire setup.
Specs
Ranked in these QuestionsQuestion Ranking
Pros
Pro Software compatible with the Raspberry Pi
ODROID-W is compatible with the Raspberry Pi at least as far as software goes. It can run any software built for the Pi.
Pro Amazing heat dissipation
The ODROID-W has some great heat dissipation. From studying the heat of the heatsink, the maximum temperature registered was 37 degrees Celsius, and that was registered when the board was doing a lot of unpacking through apt-get. Normally the temperature is even lower than that.
Pro Can fit most Pi cases
Since it's built to emulate the Raspberry Pi, it's roughly the same shape albeit a bit smaller. But even then it should be able to fit most Raspberry Pi cases.
Pro Comes with appropriate case and mounting hardware for storage drives
While the cost may seem steep compared to other SBC options, seldom are those other options sold with a case that will also house your storage drives and provide adequate cooling for the entire setup.
Pro SATA III port and M.2 NVMe connector with on-board RAID-0/RAID-1 controller
The ability to harness the power of a standard 2.5" SATA III drive and an M.2 NVMe drive with four PCI Express 3.0 lanes means that sequential read rates in excess of 3GB/sec if both are SSDs. Add to that hardware RAID support and it's hard to imagine a more powerful digital storage platform anywhere near this size.
Cons
Con Obsolete
Don't fall in love, this model is no longer available.
Con No on-board Ethernet
The ODROID-W has no on-board Ethernet port available, however this can be fixed by using a docking board which has an Ethernet jack.
Con Needs a multi-USB hub
Since it only has a USB host connector available for a full-sized port, you most certainly will need a multi-USB hub to connect more than one external devices to the board.
Con Higher initial costs than most other options
It's clearly not a budget option for building a home NAS, but if you want performance and more importantly, scalability, then you'll reap the benefits of the extra upfront costs many times over as you upgrade the memory, add peripherals via USB-C and put that 7th Generation Core i3 processor to work.