When comparing Cooper Aspire RF Wireless 15A Switch vs GE Z-Wave In-Wall Smart Switch, the Slant community recommends GE Z-Wave In-Wall Smart Switch for most people. In the question“What are the best Z-Wave light switches?” GE Z-Wave In-Wall Smart Switch is ranked 1st while Cooper Aspire RF Wireless 15A Switch is ranked 4th. The most important reason people chose GE Z-Wave In-Wall Smart Switch is:
Using a Z-Wave programmer (aka a master controller), you can essentially flip the switch's software (if you installed it upside-down, intentionally or accidentally, the software can compensate for that). Also, the LED indicator can be programmed to turn on when the light is on, which is very useful for lights you can't see - ie outdoor lights.
Ranked in these QuestionsQuestion Ranking
Pros
Pro Small LED indicator
There is a small blue LED indicator that turns on when the light is turned on. This is especially useful for outdoor lights, or garage lights where you can't always tell if they are on or not from where the switch is located.
Pro Programmable delayed turn off
This switch offers an option to automatically turn off after a set period of time - ideal for hallways where you only need light for a minute or two. This is also very useful in bedrooms - turn your lights on when you are getting ready to go to bed, then they will automatically turn off after your preferred period of time. This delay can be up to 4 minutes.
Pro Programmable
Using a Z-Wave programmer (aka a master controller), you can essentially flip the switch's software (if you installed it upside-down, intentionally or accidentally, the software can compensate for that). Also, the LED indicator can be programmed to turn on when the light is on, which is very useful for lights you can't see - ie outdoor lights.
Pro Touch controls
Tapping the switch will toggle the lights on/off, and long touching will slowly brighten or dim the lights.
Pro Small LED indicator
There is a small blue LED indicator on the bottom right of the switch. By default, it turns on when the light is off, allowing you to easier see where the switch is in the dark. If you have a Z-Wave programmer however, you can change it to be the opposite - when the light is on the LED is on. This can be useful for lights outside, or other situations where you can't immediately tell if the device is on or off.
Cons
Con Expensive
For what it offers, this is an expensive solution. It doesn't offer dimming, and the push button style of trigger isn't as flattering as a touch-enabled trigger.
Con Push button
Its looks are deceiving as the switch surface isn't capacitive - you will need to apply enough force to push the button in. When the switch actuates, it will make a small click noise.
Con Installation can be difficult
If you haven't swapped out wall switches before, it can be tricky. You will have to un-wire the old one, and wire the new one to the existing wires. The instructions use some jargon that isn't explained, which you will need to figure out before the instructions make any sense ('line' means the wire coming from the breaker, 'load' means the wire going to the light fixture, and 'traveler' means the wire(s) that runs between multiple switches that control the same light.
Con House wiring requires neutral wire
The neutral wire is needed for this wall switch - it simply won't function without it. Older houses may not have the wiring required for these switches to work.
